Two LED program

/*

Blink2

Turns on a LED on for half a second, then off for half a second, repeatedly. It also does the same to an off-board LED connected to pin 12 so that when one LED is on the other is off.

The circuit:

* LED connected from digital pin 13 to ground via resistor.

* second LED connected from digital pin 12 to ground via resistor. I used 330 ohms.

* Note: On most Arduino boards, there is already an LED on the board

connected to pin 13.

Created 1 June 2005

By David Cuartielles. Adapted by Peter Brook

based on an orginal by H. Barragan for the Wiring i/o board

*/

int ledPin = 13; // LED connected to digital pin 13

int redLedPin = 12; // LED connected to digital pin 13

int del =500;

// The setup() method runs once, when the sketch starts

void setup() {

// initialize the digital pin as an output:

pinMode(ledPin, OUTPUT);

pinMode(redLedPin, OUTPUT);

}

// the loop() method runs over and over again,

// as long as the Arduino has power

void loop()

{

digitalWrite(ledPin, HIGH); // set the LED on

digitalWrite(redLedPin, LOW); // set the LED on

delay(del); // wait

digitalWrite(ledPin, LOW); // set the LED off

digitalWrite(redLedPin, HIGH); // set the LED on

delay(del); // wait

}